Worth Data 802 RF Spécifications télécharger pdf (Page 8)

1-5

Upon power-up, the R/F Terminal displays the following opening screen:

802 TERMINAL 1XWFUnnn

ServerIP=nnn.nnn.nnn.nnn

DeviceIP=nnn.nnn.nnn.nnn

Ch:=n SSID=xxxxxxxxxxxx

WEP=128 Rnn

HIT ANY KEY

(The opening screen can be bypassed upon power up. See Chapter 2)

• The first line on the screen, 802 TERMINAL WFUnnn, gives the

firmware revision number.

• Server IP either shows the Server's fixed TCPIP address; or if

Device searches out the Server, shows 0.0.0.0.

• Device IP either shows the Device's fixed TCPIP address or if it

is determined by a DHCP Server, shows 0.0.0.0.

• Ch:=nn shows the channel to start using, (the channel of the most

frequently used Access Point, 01-11).

• SSID=xxxxxxxxxxxx refers to the first 12 characters of the up

32 ch character network name.

• WEP=128 or 64 or NO shows how the Device is configured

with an encryption key.

• Rnn=the radio firmware version.

To move on to the first menu item, press any key on the R/F Terminal keypad.

The display now reads:

DEVICE SIGN ON ----->1

SETUP MODE----------->2

SITE SURVEY----------->3

• Press the 1 key to initiate to a two-way communication host

computer program through an Access Point.

• Press the 2 key to change the configuration of the Terminal Device.

• Press the 3 key to survey the intended site for adequate coverage.

This screen can be skipped (see Chapter 2; RF System Setup), causing the R/F

Terminal to automatically enter DEVICE SIGN ON at power up.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 118 119

Pas de commentaire

Worth Data 802 RF Spécifications Page 8