Worth Data 5202D Scanner Manuel d'instructions télécharger pdf (Page 9)

Set to factory default:

To set the scanner to factory defaults, scan one of the codes below.

Set USB I/F and Reset All Settings to Default

Set RS-232 I/F and Reset All Settings to Default

Note: The RS-232 I/F setting applies to the 520-2D when used as an external scanner attached to

portable devices such as the Terminal and TriCoder.

Warning: These setup codes are for the 520-2D only. Do not use these codes to setup the 2D

scanner on a 2D integrated Terminal or TriCoder. Use the internal menu to configure those

units.

A-3

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Pas de commentaire

Worth Data 5202D Scanner Manuel d'instructions Page 9